Additional changes to make after upgrading the K2 Summit IP codec module
You will need to make the following system changes after you upgrade the codec module.
- From Windows 10 Control Panel, select Network and Internet>Network and Sharing Center.
- Select Change adapter settings.
- Rename both new Local Area Connections to Media Connection 10G #1 and #2.
-
Click on Advanced> Advanced Settings.
- In the connections box, move both Media Connection 10G #X to be above the existing Media Connections and below anything that was above the existing Media Connections (for example, Loopback).
- For both, right click on Media Connection 10G #X device, select Properties.
- From the Networking tab from Properties window, select Configure.
- From the Configure dialog, select the Advanced tab.
- Select Performance Options from Setting, then click Properties. Make the following changes: