Install the bezel ears and bezel

  1. Remove the 10-32 rack screw from the middle hole in the bottom rack unit.

  2. Install the left ear with the 390772100 bracket, to the left side of the chassis. Hook the top first and snap in the bottom. Then open the trap door and put in the 10-32 screw. If the screw head is too big to fit through the trap door, you can put it on the side of the ear before mounting the ear.

  3. Remove the two 10-32 screws from the front right of the chassis.

  4. Install the Grass Valley part 390771300, BRKT, RIGTH RACK EAR ADAPTER (NEC M110), with the two 10-32 screws back into the same two holes, with the threaded hole tab, coming from the lower right.

  5. Insert the two tabs on the left sited of the 751054500, FACE PLATE, (NEC M110), into the slots on the left ear.

  6. Tighten the thumb screw into the threaded hole on the right side tab.


Copyright © 2005 - 2020 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. K2 Summit 10.1.4 gvtp_20201103_00:48:25