Verify/configure SNFS configuration file on K2 Media Servers
In this task you open the media file system (SNFS) configuration file and verify/modify settings.
Do this task if you access media on a K2 SAN and in the SNFS configuration file, WindowsSecurity is set to No. If you are not sure about the WindowsSecurity setting, proceed with this task to check the setting.
You can verify and, if necessary, modify the media file system (SNFS) configuration file and still keep your media file system intact if you carefully follow the steps in this procedure.
This task applies to the following devices:
- On a K2 Media Server, using Notepad, open the media file system (SNFS) configuration file: The configuration file can be either D:\SNFS\config\default.cfg. or D:\SNFS\config\gvfs_hostname.cfg, where hostname is the name of the primary file system server (FSM).
- Locate the WindowsSecurity setting and proceed as follows:
-
On a K2 Media Server, verify, and if necessary
modify, settings for required values as follows:
# ********************************************************* # A global section for defining file system-wide parameters # ********************************************************* . WindowsSecurity No GlobalSuperUser Yes UnixDirectoryCreationModeOnWindows 0777 UnixFileCreationModeOnWindows 0666 .
- Close, and if necessary save, the SNFS configuration file.