Installing SSD upgrade
This section provides instructions for the following
field kits:
Refer to related topics in the "Configuring the K2 System" section of this Topic Library as necessary for detailed information on the following steps.
- Backup any media on the standalone K2 Summit 3G system that you must retain after the upgrade.
- Unbind existing Hard Disk Drive (HDD) LUNs.
- Power down the K2 Summit 3G system.
- Remove the existing HDDs.
- Install the Solid State Drives (SSD).
- Power up the K2 Summit 3G system.
- Open Storage Utility independently and verify that the SSDs are displayed.
- Check firmware versions on the drives and refer to compatibility information in the "About This Release" section of the K2 Topic Library. Upgrade firmware if required.
- Bind SSDs as RAID 1 LUNs.
-
Make a new media file system.
The K2 Summit 3G system restarts.
-
In Storage Utility, click Tools | Modify File System and
verify or set the RTIO value as specified for your use of the K2 Summit 3G system.
The K2 Summit 3G system restarts.
- Restore any media that you backed up earlier in this procedure.