Codec option card removal

Before doing this task, remove the codec module.

To remove a codec option card from the codec module, proceed as illustrated.

Use a #1 Phillips screwdriver to remove the screws.

After installing the replacement card, install the current version of K2 software. An over-install is all that is required. You do not need to first un-install the software. This ensures that the card is flashed with the proper version to be compatible with K2 software.

Note: Once a channel is operational with MPEG-2 or AVC-Intra, if you then remove the cards from the codec module you must also delete C:/profile/config/config.xml. Failure to do so causes errors in Configuration Manager.

Copyright © 2005 - 2020 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. K2 Summit 10.1.4 gvtp_20201103_00:48:25