Midplane board removal

Before doing this task, remove the front bezel assembly, top cover, disk controller board, front interconnect board, disk modules, and disk backplane unit.

A screwdriver with a shaft at least 7 inches long is recommended. Use the following view of the midplane board to help you locate screws.



  1. Disengage all rear FRU modules so that they are not connected to the midplane board.
  2. To remove the midplane board, proceed as illustrated.






Copyright © 2005 - 2020 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. K2 Summit 10.1.4 gvtp_20201103_00:48:25