Control point PC description
A control point PC runs applications from which you operate, configure, and monitor the K2 SAN. You can have one or more PCs that provide control point functionality. You must have at least one control point PC on which you install and run the K2Config application.
The primary applications that run on a control point PC are as follows:
In addition, you can use the control point PC for the following applications:
You can purchase a control point PC from Grass Valley. In this case the PC has all the above software pre-installed at the factory. When you receive the PC it is ready to install on the K2 SAN control network and begin using with minimal configuration.
You can also build your own control point PC by installing and configuring software on an existing PC. Refer to the K2 System Guide for specifications and instructions.