Installing the Fibre Channel card driver

When you restore a K2 Media Server from the generic disk image, the 8Gb Fibre Channel card driver is not on the disk image. After restoring the disk image, you must install the Fibre Channel card driver as instructed in this procedure.

  1. After restoring the disk image and restarting the K2 Media Server, a Found New Hardware wizard opens. Dismiss the wizard and continue with this procedure.
  2. Navigate to the following directory: C:\Profile\Drivers\Atto 8Gb HBA Drivers
  3. Open the directory for the K2 Media Server platform on which you are installing, as follows:
    Directory Platform type
    x64 64 bit
    x86 32 bit
  4. Open setup.exe. An install wizard opens.
  5. Restart the K2 Media Server

Copyright © 2005 - 2020 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. K2 Summit 10.1.4 gvtp_20201103_00:48:25