Configure Network Configuration page - Client

The client actually has four Gigabit Ethernet ports, but two ports are configured as a teamed pair (the control team), while the other two ports (the media connections) are individual. The teamed pair shares an IP address and appears on this page as a single port.

This page configures both control and media (iSCSI or LAN Connect) network connections.

  1. Verify that the top port is configured correctly. The top port is the port over which the K2Config application is communicating. If correctly configured, it is already assigned the control network IP address, as displayed on this page.
  2. Select Media Connection #1 and then click Modify. A network configuration dialog box opens.
  3. Verify or configure Media Connection #1 as follows:
    • If a redundant K2 SAN, verify or enter an IP address for the “A” media (iSCSI or LAN Connect) network. Also enter the subnet mask.
  4. Do one of the following:
    • If a redundant K2 SAN, proceed with the next step and configure Media Connection #2.
  5. Select Media Connection #2 and then click Modify. A network configuration dialog box opens.
  6. Verify or enter an IP address for the “B” media (iSCSI or LAN Connect) network. Also enter the subnet mask.
  7. Click Next.

The Database Client Configuration page opens.


Copyright © 2005 - 2020 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. K2 Summit 10.1.4 gvtp_20201103_00:48:25