Powering off K2 G10v2 RAID
- On the primary RAID chassis controller, identify the Ready LED. It blinks at a rate of 1 blink per second during normal operation.
-
Tap the power button on a RAID controller. If you
have two controllers, you can tap the power button on either RAID controller 0
or RAID controller 1.
Note: Do not press and hold down the power button.After tapping the power button, the Ready LED blinks more quickly, at a rate of about 2 blinks per second. The power button on the RAID controller turns off power for the primary RAID chassis and any connected Expansion chassis. Power-off normally occurs within 20 seconds and is indicated when LEDs other than those on the power supplies go off and the fans stop rotating.
- Wait for RAID power-off to complete before proceeding.
- Power-off all Ethernet switches.
- Power-off the control point PC and/or the SNMP manager PC, if necessary.