Restoring from the system-specific recovery disk image on E: Dell server

Use this task to restore a server using an image made from that particular server. If restoring from a generic factory default image, do not use this task.

  1. Make sure that media access is stopped and that the system on which you are working is not being used.
  2. Connect all motherboard NICs to LAN connections.
  3. If you have not already done so, connect keyboard, monitor, and mouse.
  4. Do the following:
    1. Insert the Recovery Flash Drive.
    2. Restart the machine. If there is a problem restarting, hold the standby button down for five seconds to force a hard shutdown. Then press the standby button again to startup.
    The system boots from the Recovery Flash Drive. The Acronis program loads.
  5. On the Acronis Rescue Media page, select Acronis Backup and Recovery 11.5 (64-bit...) The Acronis Backup and Recovery page opens.
  6. On the Acronis Backup and Recovery page, select Recover. The Recover Data page opens.
  7. On the Recover Data page, under What to Recover page, select Select Data. The Data to Recover Selection dialog box opens.
  8. On the Data to Recover Selection dialog box, do the following:
    1. Select Browse.
    2. In the tree view, expand the Local Folders node.
    3. Select the USB drive that contains the FT disk image.
    4. Click OK.
    On the Archive View tab, your backup name is listed.
  9. On the Archive View tab, select your backup.
  10. Under Backup contents, do the following:
    1. Select C: and D:.
    2. Click OK.
    The Data to Recover Selection dialog box closes.
  11. On the Recover data page, under Where to recover, verify the following:
    Recover to: Physical machine
    Clear all
    Recover the 'NTFS' partition with MB size to... Properties: System Reserved ..Size:....MB ..Letter: D
    Clear Disk 1/NTFS (D:)
    Recover the 'NTFS' partition with GB size to... Properties: NTFS ..Size:...GB ..Letter: C
    Clear Disk 1/NTFS (C:)
  12. On the Recover Data page, click OK. The restore process begins.
  13. On the My Recovery Details page, select the Progress tab to view the progress. The image loads in approximately 9 minutes.
  14. When the data is successfully restored, click OK.
  15. Close all Acronis pages and the Acronis main window. The machine restarts automatically.
  16. Remove the recovery media while the machine is shutting down.

Copyright © 2005 - 2020 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. K2 Summit 10.1.4 gvtp_20201103_00:48:25