Name team and loopback
-
On the Windows desktop right-click Start | Control Panel | Network and
Sharing Center | Change adapter settings. The Network
Connections window opens.
- For the Control Team and the loopback, select adapter names in the “Device Name” column and rename them as follows:
-
Do one of the following:
- If you intend to use SiteConfig for device discovery and IP address configuration, you do not need to set an IP address for the Control Team at this time. You are done with this procedure.
- If you are not using SiteConfig, set an IP address for the Control Team at this time. Use standard Windows procedures.
Note: Do not set IP addresses for the two Media Connections.