Restoring settings after generic reimage
Settings must be saved using psave.bat before reimaging the K2 Summit system, and the reimage (Acronis) process must be complete.
- If you have not already done so, start up the K2 Summit system and log on with administrator privileges.
- Connect the USB Recovery Flash Drive to a USB port on the K2 Summit system.
-
From the USB Recovery Flash Drive, run the
following and wait for the process to complete:
Tools\SaveRestoreScripts\prestore.bat
Next, do the following as appropriate to restore your K2 Summit system. Refer to related topics in this
document or as otherwise indicated.
- Restore network configuration. If you saved settings with psave.bat, refer to C:\ipconfig.txt for the complete listing of the network settings that the K2 Summit system had before reimaging.
- Enhance network bandwidth.
- Install the SiteConfig Discovery Agent.
- If you install software with SiteConfig, do the following:
- Take Embedded Security out of Update mode.
- Install SNFS software and K2 software using SiteConfig.
- Restore SabreTooth licenses.
- If you install software manually (without SiteConfig), do the
following:
- Install SNFS software and K2 software manually.
- Take Embedded Security out of Update mode.
- Restore SabreTooth licenses.
If you saved/restored settings with psave.bat and prestore.bat, SNFS uses the restored settings.
- If a K2 Summit system with direct-connect storage or shared storage on a redundant K2 SAN, install MPIO software.
- If a K2 Summit system with a Fibre Channel card, install the Fibre Channel Card driver. Refer to related topics in "K2 Summit Production Client Service Manual".
- If a K2 Summit SAN-attached system, on the K2 SAN’s control point PC, use the K2Config application to add the K2 Summit system back to the SAN
- Check the Windows operating system clock, and if necessary, set it to the correct time.
- Activate Windows within 30 days.