DynoZoom board installation

Before doing this task, the carrier module must be removed.

  1. On the K2 Summit system, use Embedded Security Manager and put the local computer in Update Mode.
  2. Shutdown the K2 Summit system.
  3. Disconnect cabling as necessary and remove the carrier module.
  4. To install the DynoZoom board, assemble the carrier module as illustrated.

  5. Install the carrier module and reconnect cabling on the K2 Summit system.
Next, make the PCIe connection between the DynoZoom board and the DynoZoom Frame. Make 4K in/out connections as well.

Copyright © 2014 Grass Valley. All rights reserved. K2 Summit 9.3 gvtp_20140914_19:56:32