Using AMP protocol to control K2 systems

Advanced Media Protocol (AMP) is an extension of the Odetics protocol.

AMP commands are available via Ethernet or RS-422 serial ports.

The automation setting for preroll should be at least 10 frames.

Preroll is 1 second for mixed compression format playout. Preroll is 10 frames for same compression format playout.

The AMP's socket interface uses IANA assigned port number 3811 for TCP.

In AppCenter, you must set a channel’s options to enable protocol control of the channel. Subsequently, when the K2 Summit/Solo system starts up, the channel is immediately available for protocol control. Manual log on is not required.

For channels in gang mode, the protocol must connect to the lowest numbered channel in the gang. This is required to support jog/shuttle of ganged channels.


Copyright © 2014 Grass Valley. All rights reserved. K2 Summit 9.3 gvtp_20140914_19:56:32