Using BVW protocol to control K2 systems

BVW commands are available via RS-422 serial ports.

A subset of BVW commands is supported through AppCenter in protocol mode.

Insert/Edit is not supported.

In AppCenter, you must set a channel’s options to enable protocol control of the channel. Subsequently, when the K2 Summit/Solo system starts up, the channel is immediately available for protocol control. Manual log on is not required.

For channels in gang mode, the protocol must connect to the lowest numbered channel in the gang. This is required to support jog/shuttle of ganged channels.

To set in and out points with BVW protocol, load clips only from the working bin.


Copyright © 2014 Grass Valley. All rights reserved. K2 Summit 9.3 gvtp_20140914_19:56:32