Modifying K2 client media (iSCSI) network settings

If IP address to which you are changing is in a different subnet, do not use this procedure. Instead, remove, then add the K2 client.

If the iSCSI network address to which you are changing is within the same subnet and range as the current iSCSI network, use the following procedure.

  1. Stop media access on the K2 client.
  2. Use SiteConfig to change the IP address. Make sure that the IP address is within the subnet and range designated for the network.
  3. In the K2 System Configuration application, open the Network configuration page for the K2 client.
  4. Verify that the IP address updates correctly.
  5. Restart the K2 client.

Copyright © 2014 Grass Valley. All rights reserved. K2 Summit 9.3 gvtp_20140914_19:56:32