Setting up the control point PC

To set up the Control Point PC, you have the following options:

  • Use the Grass Valley Control Point PC that comes from the factory with software pre-installed.
  • Use a PC that you own and install the required software.

  1. For either option, you must do the following for the Control Point PC that runs the K2 System Configuration application:
    1. Assign a control network IP address to the PC.
    2. Connect the PC to the GigE control network.
  2. To use your own PC, you must additionally do the following:
    1. Verify that the PC meets system requirements.
    2. Install the K2 Control Point software.
    3. Install SiteConfig software.
    4. Install other supporting software.
    5. Install and license SNMP Manager software. This can be on the K2 SAN control point PC or on a separate SNMP Manager PC that monitors the K2 SAN.

      Refer to related topics about Grass Valley recommended deployment and monitoring solutions in the "About This Release" section of the K2 Topic Library.


Copyright © 2014 Grass Valley. All rights reserved. K2 Summit 9.3 gvtp_20140914_19:56:32