Installing Multi-Path I/O Software on a direct-connect K2 system

Before doing this task, if a K2 Summit system with K2 software version lower than 9.0, make sure the write filter is disabled.

The following procedure is required for direct-connect K2 systems.

The files for the Multi-Path I/O software are copied on to the K2 system when the K2 software is installed.

  1. Access the Windows desktop on the computer on which you are installing MPIO. You can do this locally with a connected keyboard, mouse, and monitor or remotely via the Windows Remote Desktop Connection.
  2. Stop all media access. If AppCenter is open, close it.
  3. Click Start | Run, type cmd and press Enter. The MS-DOS command prompt window opens.
  4. From the command prompt, navigate to the C:\profile\mpio directory.
  5. Type one of the following at the command prompt:
    • If installing on a 32-bit computer:

      gdsminstall.exe -i c:\profile\mpio gdsm.inf Root\GDSM

    • If installing on a 64-bit computer:

      gdsminstall64.exe -i

  6. Press Enter. The software is installed. The command prompt window reports progress.
  7. Restart the computer on which you installed MPIO.
  8. After restart, to verify that the software is installed, on the Windows desktop right-click My Computer and select Manage. The Computer Management window opens.

  9. In the left pane select Device Manager.
  10. In the right pane open the System devices node and verify that GVG ISCSI Multi-Path Device Specific Module is listed.

Copyright © 2014 Grass Valley. All rights reserved. K2 Summit 9.3 gvtp_20140914_19:56:32