Other Topic Library Versions

Deploy control point PC software

Use SiteConfig to upgrade control point software on the K2 control point PC. In most cases, the K2 control point PC is also the SiteConfig control point PC, so you are in effect using SiteConfig to upgrade software on its own local system.

For this release of K2 software, the install task identifies the control point software in the Managed Package column as follows:
  • GrassValleyControlPoint 9.5

The software deployment process for the control point PC is similar to that used to upgrade software on other K2 devices. Use similar procedures and adjust accordingly to do the following:

  1. Add the K2 control point software package to the deployment group that contains the control point PC.
  2. Check software on the control point PC.
    Note: If an "Unable to copy ... to target" error appears for a device that has Grass Valley Embedded Security, put Embedded Security in Update mode.
  3. Configure and run deployment tasks to upgrade software.

Copyright © 2015 Grass Valley USA, LLC. All rights reserved. K2 Summit 9.5 gvtp_20151106_14:27:14