Upgrade RAID controller microcode

Do not do this task if:

The K2 RAID controller and expansion chassis microcode is already at compatible versions, as listed in Compatible K2 RAID components.
The K2 RAID is a Level 2 or Level 3.

Do this task if:

The K2 RAID controller and/or expansion chassis microcode is at a version that is not compatible.

The microcode files are copied on to the K2 Media Server when the K2 system software is installed.

Refer to the K2 RAID compatibility specifications earlier in these release notes for the version to which you must upgrade and for the file names for the microcode files.
Use Storage Utility to upgrade microcode. Refer to the K2 SAN Installation and Service Manual for procedures. The procedure for K2 10Gv2 RAID is different than the procedure for other types of K2 RAID. For the K2 10Gv2 RAID procedure, you can refer to a related topic in this document, as well as in the K2 SAN Installation and Service Manual.
On 100% completion, proceed as follows:
- If the RAID controller chassis has redundant controllers, power cycle the RAID controller chassis, then restart the K2 Media Server.
- If the RAID controller chassis does not have redundant controllers, no power cycle is required. The firmware download is complete.