Other Topic Library Versions

Prerequisites for initial configuration - Basic K2 SAN

Before beginning your initial configuration, make sure the devices of the K2 SAN meet the following prerequisites.

Control point PC

  • Ethernet cable connected
  • Control Point software must be installed
  • Control network IP address must be assigned
  • There must be network communication over the control network with all other K2 devices
  • Power must be on

Ethernet switch

  • Ethernet cables connected
  • Control network IP address must be assigned
  • VLANs must be set up
  • Trunks must be set up
  • Power must be on

K2 Media Server

  • Ethernet cables connected
  • Fibre Channel cable must be connected
  • Softwaremust be installed, as from the factory, including QuickTime 7
  • Control network IP address must be assigned
  • Power must be on for all servers

K2 RAID chassis

  • Fibre Channel cable(s) must be connected
  • Ethernet cable(s) must be connected
  • Power must be on

K2 RAID Expansion chassis (optional)

  • Fibre channel cable(s) must be connected
  • Power must be on

Copyright © 2015 Grass Valley USA, LLC. All rights reserved. K2 Summit 9.5 gvtp_20151106_14:27:14