Other Topic Library Versions

Configure Network Configuration page - K2 client



This page configures both control and media (iSCSI) network connections.

The K2 client actually has four Gigabit Ethernet ports, but two ports are configured as a teamed pair (the control team), while the other two ports (the media connections) are individual. The teamed pair shares an IP address and appears on this page as a single port.

  1. Verify that the top port is configured correctly. The top port is the port over which the K2Config application is communicating. If correctly configured, it is already assigned the control network IP address, as displayed on this page.
  2. Select Media Connection #1 and then click Modify. A network configuration dialog box opens.
  3. Verify or configure Media Connection #1 as follows:
    • If a basic (non-redundant) K2 SAN, verify or enter the media network IP address. Also enter the subnet mask.
    • If a redundant K2 SAN, verify or enter an IP address for the “A” media (iSCSI) network. Also enter the subnet mask.
  4. Do one of the following:
    • If a basic (non-redundant) K2 SAN, skip to the last step in this procedure. Do not configure Media Connection #2.
    • If a redundant K2 SAN, proceed with the next step and configure Media Connection #2.
  5. Select Media Connection #2 and then click Modify. A network configuration dialog box opens.
  6. Verify or enter an IP address for the “B” media (iSCSI) network. Also enter the subnet mask.
  7. Click Next.

The Database Client Configuration page opens.


Copyright © 2015 Grass Valley USA, LLC. All rights reserved. K2 Summit 9.5 gvtp_20151106_14:27:14