Other Topic Library Versions

Powering off K2 G10v2 RAID

  • K2 Media Servers must be powered off
  1. On the primary RAID chassis controller, identify the Ready LED. It blinks at a rate of 1 blink per second during normal operation.
  2. Tap the power button on a RAID controller. If you have two controllers, you can tap the power button on either RAID controller 0 or RAID controller 1.
    Note: Do not press and hold down the power button.
    After tapping the power button, the Ready LED blinks more quickly, at a rate of about 2 blinks per second. The power button on the RAID controller turns off power for the primary RAID chassis and any connected Expansion chassis. Power-off normally occurs within 20 seconds and is indicated when LEDs other than those on the power supplies go off and the fans stop rotating.
  3. Wait for RAID power-off to complete before proceeding.
  4. Power-off all Ethernet switches.
  5. Power-off the control point PC and/or the SNMP manager PC, if necessary.

Next, power off remaining SAN devices.


Copyright © 2015 Grass Valley USA, LLC. All rights reserved. K2 Summit 9.5 gvtp_20151106_14:27:14