Other Topic Library Versions

Powering on the HP ProCurve switch

Use the following procedure to power on and verify proper operation of the HP ProCurve switch.

  1. Power up the switch.
  2. Watch LEDs to verify proper operation. The diagnostic self test LED Behavior is as follows:
    • Initially, all the status, LED Mode and port LEDs are on for most of the duration of the test.
    • Most of the LEDs go off and then may come on again during phases of the self test. For the duration of the self test, the Test LED stays on.
    If the ports are connected to active network devices, the LEDs behave according to the LED Mode selected. In the default view mode (Link), the LEDs should be on. If the ports are not connected to active network devices, the LEDs will stay off.

Copyright © 2015 Grass Valley USA, LLC. All rights reserved. K2 Summit 9.5 gvtp_20151106_14:27:14