Other Topic Library Versions

Saving settings

Do this task for both software and CPU carrier module upgrade kits.

Before doing this task, the 16GB USB Recovery Flash Drive that you received with the kit must have the serial number of the K2 Summit/Solo system written on it to identify it as belonging to that individual system.

Note: Do not attempt to use a single Recovery Flash Drive on multiple systems. This can overwrite saved settings and lose the ability to restore settings on one or more systems. Also, software licensing requires one Recovery Flash Drive for each system.
  1. If you are working on a K2 client SAN-attached system, record iSCSI bandwidth settings, so you can reconfigure after removing and readding to SAN.
  2. Make sure you are logged in to the K2 Summit/Solo system with administrator privileges.
  3. Connect the USB Recovery Flash Drive to a USB port on the K2 Summit/Solo system.
  4. On the USB Recovery Flash Drive, navigate to the following location: \tools\SaveRestoreScripts.
    Note: Do not attempt to use the same Recovery Flash Drive on multiple systems.
  5. Run the following and wait for the process to complete: ssave.bat

    This saves current settings onto the USB Recovery Flash Drive in the \settings directory.

  6. Disconnect the USB Recovery Flash Drive.
Next, do one of the following:
  • If you are installing K2-XDP2-V9-FK on a K2 Summit 3G system with mSATA system drive, skip ahead and reimage.
  • If you are installing K2-XDP2-V9-FK on a K2 Summit/Solo system with CompactFlash system drive, skip ahead and replace the CompactFlash boot media with the new larger 16GB CF.
  • If you are installing K2-XDP2-CPU-FK on a K2 Summit system, replace the CPU carrier module.

Copyright © 2016 Grass Valley Canada. All rights reserved. K2 Summit 9.6 gvtp_20160520_13:06:36