Moving clip mark-in/mark-out points

Every clip has a mark-in point and a mark-out point that refer to the first and last frames displayed when the clip is played. When first recorded, clip marks are set to the beginning and end of available media. You can edit the clip marks in order to reference only the desired media. When clip marks are moved, the unused media is not deleted. Clearing the marks resets them to the first and last frames of the recorded clip.

Note: If the source media has been erased, the subclip retains 1 second of media on each side of the mark-in and mark-out points.

The following restrictions apply when editing clip marks:

Mark-in must precede the mark-out
Marks cannot be set outside the recorded media
Marks cannot be changed on a clip that is still being recorded.

Note: If more media exists after the current mark, a <<< or >>> symbol is displayed beneath the In/Out timecode. To permanently remove media outside the marks, refer to “Erasing a clip's unused media” under Managing Clip Media.

To move clip marks, load the clip in player, then use one of the following methods.

Moving clip marks: Using the In/Out buttons
Moving clip marks: Using the timecode entry controls
Moving clip marks: Using the clip length control