Other Topic Library Versions

Name team and loopback

  • Adapters must be named
  • The control team must be created
  1. On the Windows desktop right-click Start | Control Panel | Network and Sharing Center | Change adapter settings. The Network Connections window opens.

  2. For the Control Team and the loopback, select adapter names in the “Device Name” column and rename them as follows:
    1. Select the adapter name.
    2. Select File | Rename to enter rename mode.
    3. Type the name, as specified in the following table:
      In the Device Name column, select this adapter name… And rename it as follows:
      TEAM : Control Team Control Team
  3. Do one of the following:
    • If you intend to use SiteConfig for device discovery and IP address configuration, you do not need to set an IP address for the Control Team at this time. You are done with this procedure.
    • If you are not using SiteConfig, set an IP address for the Control Team at this time. Use standard Windows procedures.
    Note: Do not set IP addresses for the two Media Connections.

If continuing with network configuration, your next task is to reorder adapters.


Copyright © 2016 Grass Valley Canada. All rights reserved. K2 Summit 9.6 gvtp_20160520_13:06:36