Other Topic Library Versions

Prepare K2 Central

  1. Shutdown any DynoS controllers connected to Summits in the system.
  2. Shutdown and disconnect any clients connected to K2Central.
  3. Shutdown and turn off power to K2Central.
  4. Ensure a keyboard, mouse and monitor are connected to K2Central.
  5. Ensure the RAID Controller Card is in K2Central slot 2. When looking at K2Central from the back slot 2 is the second slot from the right. If it is not in slot 2 move the RAID Controller Card to slot 2.

  6. Pull the media drives so they are disconnected from the backplane. Only pull them enough to disconnect them. They do not need to be removed from the chassis. Hint: Open carrier levers for all drives then pull individual drives top to bottom starting with the right-most column. This is quick and the open carrier levers don’t hang up on the adjacent drives. Otherwise open the carrier lever and pull the drive one at a time.

Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170317_08:51:20