Other Topic Library Versions

Cable K2 RAID

Before cabling, install the K2 RAID chassis in its permanent location. After mounting the chassis in the rack, you must secure brackets to the front rail to support the Grass Valley bezel. Refer to related topics in the "Installing and Servicing the K2 SAN" section of the K2 Topic Library for rack mount instructions.

You do not need to manually set a Fibre Channel address ID on controllers or a chassis address on Expansion chassis.

As directed by the system diagram for your storage system, cable the K2 RAID devices using the instructions in this section.

Once the RAID storage is connected and configured, do not swap Expansion chassis or otherwise reconfigure storage. If you connect an Expansion chassis in a different order or to the wrong controller, the controller will see a configuration mismatch and fault.


Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170317_08:51:20