Other Topic Library Versions

Configure live streaming multicast

This task describes the configuration of multicast settings using AppCenter.

  1. In AppCenter, click System | Configuration. Configuration Manager opens.
  2. In Configuration Manager, click the System tab.

    These settings apply to all channels on the K2 Summit system.

  3. In Proxy Setup settings, select and enter the Multicast port base. This is the first UDP port address for elementary streams.
  4. To set the multicast IP base address for each channel independently, set Manual live stream IP address config to Yes.
  5. Select Multicast IP base (x.y.0.0).

    The K2 Summit system applies channel-specific IP addresses from this base.

  6. Enter the IP address in the Multicast IP base (x.y.0.0) dialog box.
  7. Click OK.
  8. Click OK to apply the settings.

Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170317_08:51:20