Other Topic Library Versions

Restoring settings after generic reimage

Settings must be saved using ssave.bat before reimaging the K2 Solo system, and the reimage (Acronis) process must be complete.

  1. If you have not already done so, start up the K2 Solo system and log on with administrator privileges.
  2. Connect the USB Recovery Flash Drive to a USB port on the K2 Solo system.
  3. From the USB Recovery Flash Drive, run the following and wait for the process to complete:

    Tools\SaveRestoreScripts\srestore.bat

Next, do the following as appropriate to restore your K2 Solo system. Refer to related topics in this document or as otherwise indicated.
  1. Restore network configuration. If you saved settings with ssave.bat, refer to C:\ipconfig.txt for the complete listing of the network settings that the K2 Solo system had before reimaging.
  2. Enhance network bandwidth.
  3. Install the SiteConfig Discovery Agent.
  4. If you install software with SiteConfig, do the following:
    • Take Embedded Security out of Update mode.
    • Install SNFS software and K2 software using SiteConfig.
    • Restore SabreTooth licenses.
  5. If you install software manually (without SiteConfig), do the following:
    • Install SNFS software and K2 software manually.
    • Restore SabreTooth licenses.

    If you saved/restored settings with ssave.bat and srestore.bat, SNFS uses the restored settings. Refer to related topics in the "About This Release" section of the K2 Topic Library.

  6. Check the Windows operating system clock, and if necessary, set it to the correct time.
  7. Activate Windows within 30 days.

Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170317_08:51:20