Final steps for software and CPU carrier module upgrades

Do this task for both software and CPU carrier module upgrade kits.

If you have not already done so, manage the Embedded Security. Make sure Update mode is ended.
Check the Windows operating system clock and, if necessary, set it to the correct time.
If you installed K2-XDP2-V9-FK, apply the Windows operating system sticker that you received with the upgrade kit. Attach it to the K2 Summit/Solo system, in the same location as the previous Windows operating system sticker.
If you are upgrading a K2 Summit SAN-attached system, on the K2 SAN’s control point PC, use the K2Config application to add the K2 Summit system back to the SAN.
When the K2 Summit/Solo system is fully configured, licensed, and operational, create a disk image and store it on the USB Recovery Flash Drive. Refer to the K2 product's service procedures.
Disconnect the USB Recovery Flash Drive and store it in the front bezel assembly.
If present, discard the previous USB Recovery Flash Drive.

The upgrade process is complete for the following upgrade kits:

K2-XDP2-CPU-FK
K2-XDP2-V9-FK

For a K2 Summit system upgraded with the K2-XDP2-CPU-FK kit, if you do any service work or replace any Field Replaceable Units (FRUs), first consult 3G service procedures in the "Servicing the K2 Summit system" section of the K2 Topic Library. This is true even if replacing an original FRU that has not been upgraded. System dependencies involving FRUs require 3G service procedures.