Other Topic Library Versions

Removing and replacing FRUs

Field Replaceable Units (FRUs) are modular hardware components that can be serviced without disturbing other components in the system.

The pictures in the following topics show how to disassemble. Unless otherwise documented, re-assembly is the reverse.

Unless otherwise indicated, you need only a Torx tool with T15 magnetic tip to remove and replace parts in the K2 Summit system.

Note: Only Grass Valley components are supported. Do not attempt to use components procured from a different source.
Note: Do not discard any hardware unless specifically instructed to do so.
DANGER
To avoid serious injury from high currents, ensure that both power cords are disconnected prior to removing or replacing any parts.
CAUTION:
This system contains board-level components that must be protected from static discharge and physical shock. Wear a wrist strap grounded to the system chassis when handling system components.

Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170117_17:59:42