Other Topic Library Versions

Codec module removal

Access the codec module from the rear panel. Remove as illustrated.

Note: With a firm grip on the metal (EMI) bracket, ensure the board is level and parallel to the card guides to avoid damage to the components on the edge opposite the rear panel.
CAUTION:
Improper handling can damage components on the board. Do not allow the board to come in contact with the chassis sheet metal during removal or installation. The components on the edge opposite the rear panel are the most susceptible to damage.
You must also remove any codec option (mezzanine) cards from the faulty codec module and install them on the replacement codec module.

After installing the replacement codec module, install the current version of K2 software. An over-install is all that is required. You do not need to first un-install the software. This ensures that the board is flashed with the proper version to be compatible with K2 software.


Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170117_17:59:42