Other Topic Library Versions

Installing components and dressing cables

Materials needed:

  • Cable ties, as provided in FRU kit.

When installing internal components, follow the steps below, especially for cable routing and dressing.

Note: Take care with cable dressing, as cables must be trapped in the lower chassis to maintain clearance for codec module removal and installation. Incorrectly dressed cables can damage the codec module.

When following the steps below, also refer to removal procedures earlier in this section, with re-assembly being the reverse of the removal procedure.

  1. If replacing a midplane board, install it in the chassis.
  2. If replacing a power supply, pre-dress unused cables as illustrated:



    Note: Use the faulty power supply that you removed as a model for cable dressing.
  3. If replacing a power supply, install it in the chassis.
  4. Install the carrier module.
  5. Install the rear panel.
  6. Dress and connect cables as illustrated.

  7. When cable dressing is complete, make sure that no cables protrude above the level of the drive chamber top.
  8. Install the top cover.

Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170117_17:59:42