Other Topic Library Versions

Create the Control Team

Note: Team control ports only. Do not team media ports.
  1. Open Network Connections, if it is not already open.
    1. From the Windows Start menu, in the Run or the Search programs and files box, type ncpa.cpl and press Enter.
  2. In Network Connections, view Details and identify the adapter name that maps to Control Connection #1 and the adapter name that maps to Control Connection #2.



  3. Right-click the adapter name that maps to Control Connection #1.
  4. Select Properties, then click Configure.

    The Properties dialog box opens.

  5. Select the Teaming tab.



  6. Select Team this adapter with other adapters, then click New Team. The New Team Wizard opens.
  7. Enter Control Team.

    Click Next.



  8. Select the check box for the adapter name that maps to Control Connection #1 and for the adapter name that maps to Control Connection #2. Click Next.



  9. Select Switch Fault Tolerance. Click Next.
  10. Click Finish and wait a few seconds for the adapters to be teamed.
  11. Open the Modify Team dialog box as follows:
    1. In Device Manager | Network Adapters, right-click Control Team and select Properties. The Properties dialog box opens.
    2. Select the Settings tab.
    3. Click Modify Team. A dialog box opens.
  12. On the Adapters tab, do the following:
    1. Select the top entry, which is the adapter name that maps to Control Connection #1 and click Set Primary.
    2. Select the adapter name that maps to Control Connection #2 and click Set Secondary.
  13. Click OK and OK and to close dialog boxes.
  14. Restart the K2 Summit/Solo system.

If continuing with network configuration, your next task is to name team and loopback.


Copyright © 2017 Grass Valley Canada. All rights reserved. K2 Summit 9.7 gvtp_20170117_17:59:42