Install codec module upgrade

Before installing a codec module upgrade, the K2 Summit system must have either Type II, Type III or Type IV CPU carrier module, 16 GB system drive, 16 GB or 32 GB USB Recovery Flash Drive, and K2 software version 9.x or higher.

Tools and materials needed:

Hardware as provided by upgrade kit. See description below.
Torx tool with T15 magnetic tip

This section provides instructions for the following field kit:

Upgrade Nomenclature	Description
K2-XDP2-3G-FK	K2 Summit Production Client XDP Series 3G SDI Interface field kit for K2-XDP series platforms. Includes 2ea - 3G codec modules, 2 - ea. 550W power supplies, and installation instructions. NOTE: This kit cannot be used with K2-XDT Series Summit Transmission Clients and Servers or K2-SOLO models.

CAUTION:

This system contains board-level components that must be protected from static discharge and physical shock. Wear a wrist strap grounded to the system chassis when handling system components.

Work through the task in this section.