Other Topic Library Versions

Disk controller board removal

Before doing this task, remove the front bezel assembly.

  1. To remove the disk controller board, proceed as illustrated.





  2. When installing, do the following:
    1. Make sure the board engages with the top and bottom guides.
    2. Make sure the board engages with the connectors on the disk backplane and midplane board.

After replacing the disk controller board on a K2 Summit 3G system or on any system that has a Type II (ADLINK) CPU carrier module, you must restore disk controller configuration. This includes the first generation K2 Summit system, which can have a Type II CPU carrier module that was installed in the factory or that was upgraded in the field.


Copyright © 2019 Grass Valley Canada. All rights reserved. K2 Summit 9.8 gvtp_20190519_03:02:01