Other Topic Library Versions

Loop through on K2 Summit/Solo

The Player/Recorder application has a “E-to-E (LoopThru) mode” selection on the Control menu. This mode applies when the channel is under local AppCenter control as well as when it is under remote control, for all protocols.

This “E-to-E (LoopThru) mode” feature allows you to monitor the video that is being recorded. The video is routed back essentially untouched. Any audio or timecode that is on the input video stream is still there on the loop through output. The K2 Summit/Solo system and the loop through videos must be locked to a video reference for the loop through feature to work properly. This “E-to-E (LoopThru) mode” feature should not be confused with true E to E. True E to E is not supported on the K2 Summit/Solo system.

When “E-to-E (LoopThru) mode” is not selected, the channel behaves as follows:

  • “PB” is displayed on the channel pane, next to the Timecode Source indicator.
  • When no clip is loaded, black plays out.
  • When a record operation stops, Recorder becomes Player and the clip remains in the Player. The clip’s last frame plays out.

When “E-to-E (LoopThru) mode” is selected, the channel behaves as follows:

  • “EE” is displayed on the channel pane, next to the Timecode Source indicator.
  • When no clip is loaded, the signal that is currently present at the channel input plays out.
  • When a record operation stops, Recorder stays Recorder and the clip remains in the Recorder. The signal that is currently present at the channel input plays out.

Copyright © 2019 Grass Valley Canada. All rights reserved. K2 Summit 9.8 gvtp_20190519_03:02:01