Creating a New Comparison Group
Create a new comparison group if you would like to initiate a lip-sync or motion detection comparison between the reference source and another probed source.
REQUIREMENTS: |
Make sure you meet the following conditions before beginning this procedure: |
• You have opened Audio Video Fingerprint Analyzer ( click HERE). |
• [RECOMMENDED]: You are performing this procedure as a task within the context of an approved workflow ( click HERE). |
1. On the Configuration tab, in the Fingerprint comparison setup area, right-click Comparison groups, and then click Add new group.
System Response: The Comparison group properties window appears.
2. In the Group name box, type the name you would like to give to your new comparison group.
3. Select a comparison mode.
4. Adjust the comparison group properties as required, and then click OK.
System Response: In Audio Video Fingerprint Analyzer, the new comparison group appears in the Fingerprint comparison setup area.
NOTE: Your new comparison group does not yet exist as a configured entity until you assign at least two sources to it and then click Apply all. A comparison group that has not yet been accepted by the system as a configured entity appears with an asterisk (*) beside its name. |
5. Assign at least two sources to the new comparison group (
click HERE).
6. Click Apply all.
System Response: The asterisk following the name of the new comparison group in the Fingerprint comparison setup area disappears, indicating the group is configured.
7. Make sure your desired reference source is configured as the reference (
click HERE).