iC Navigator Views
Sorting allows you to determine the way in which devices will be arranged for display in iC Navigator. Three views are available:
• Logical View arranges the devices in groups created by the user. Devices are sorted into groups, and within each group, arranged in alphabetical order. Ungrouped devices are displayed at the end of the list. Empty slots are not shown (unless they are in the Reference Config).
NOTE: The grouping is done on the Application Server, and therefore, changes apply for all users. |
• Physical View arranges the devices relative to their physical connections and network location. All frame slots are shown, even if they are empty. This is done automatically by the system. Devices are sorted by:
• the IP address of the iControl server,
• then the serial communication port of the server where the (Imaging) frame is connected,
OR,
• the IP address of the Densité communicator,
• then the frame itself.
Once the frame folder is open, you can see the device by the slot when applicable.
NOTE: Physical View may only be applied to devices in frames. |
• Flat View shows all devices in alphabetical order without any grouping.
With Logical View and Physical View, you can open and close folders in the list to display any level of the hierarchy.