Creating an Alarm by Dragging a MIB Element from the Alarm Browser Pane
REQUIREMENTS: |
Make sure you meet the following conditions before beginning this procedure: |
• You have opened SNMP Driver Creator ( click HERE). |
• You have loaded a MIB module into SNMP Driver Creator ( click HERE). |
• You are displaying the Design view in SNMP Driver Creator. |
• You have configured your driver settings ( click HERE). |
• [RECOMMENDED]: You are performing this procedure as a task within the context of an approved workflow ( click HERE). |
1. In SNMP Driver Creator, click the Alarms tab.
2. In the MIB Browser pane, select the desired MIB element from the loaded MIB modules (you may need to expand the folder tree to see it), and then drag the element to the Alarms table.
[ Graphic ]
System Response: A new alarm is created and listed in the Alarms table.
|
For more information about editing an existing alarm any time after it has been created, click HERE. |
