Determine StorNext node

Important: Enter commands below exactly as shown including upper/lower case; example output shown below the steps.
  1. Using the CLI, open a shell on StorNext VM Controller A - Bottom.

  2. Check the status of the StorNext node. You must ensure the status is primary.

  3. If LocalStatus=primary then you are on the primary StorNext node. Proceed to the next topic: Rename the file system
  4. If LocalStatus=running then you are not on the primary StorNext node. Perform the following and make necessary adjustments throughout remainder of documentation.

Parent topic: File System Naming

Copyright © 2021 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. AMS Express gvtp_20210507_00:49:21