Router Control Methods

Within the router there are 2 control methods:

  1. Direct control of router inputs, outputs and levels.
  2. Control through ‘Routemaster’ virtual router.

Method 1 provides direct control and allows control of individual inputs across all levels without the ability to program ‘breakaways’ or isolate level control. Note that breakaways can still be performed if programmed into individual panels.

Method 2 uses the Routemaster virtual router to program breakaway sources on different levels as well as combine control of multiple routers simultaneously.

Panels can be set to control either an individual router or ‘Routemaster.’

Note that you can use both direct router control or control through the Routemaster but not on the same router soft panel at the same time, unless you are using a custom panel.


© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.