Router Configuration Procedure

The procedure covers how to install a router into CommandCenter and how to configure and control it. Note: The Encore and Jupiter configuration can be more involved, especially in an existing system, in which case the naming conventions should match those in the exiting Router Control Engine.

  1. Configure the New ‘Router Control Engine’ (RCE - Encore or Jupiter). Be sure to set the RCE to enable control from the CommandCenter PC IP address.
  2. Add the router RCE to CommandCenter Network devices.
  3. Name the router.
  4. Configure the sources, destinations and level mnemonics (names) as desired.
  5. Configure the Routemaster levels, breakaways, and other routers, if present.
  6. Configure the panel templates.
  7. Add the panels to the network and associate with the templates.
  8. Create additional custom soft panels as needed.
Parent topic: Router Configuration Tasks

© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.