Exporting to a DV Device (Generic OHCI)

You can output data to DV devices.

Note
You need to register the export destination DV device as a device preset in advance. Registering Device Presets Output cannot be performed if the output format in the registered device preset for the DV device differs from the current project settings.

1) Connect the PC IEEE1394 terminal to the DV device with a DV cable.

2) Click [Export] on the Recorder.

3) Click [Print to Tape] or [Print to Tape (Display Timecode)].

Alternative

Click [File] on the menu bar, and click [Export] → [Print to Tape] or [Print to Tape (Display Timecode)].
Exporting to tape: [F12]

If the message [There is no output preset to match the project settings.] is displayed, configure the project settings and device preset format again.

4) Select a device preset, and click [Next].

The device presets that can be output with the current project settings are displayed.

5) Cueup to the position to start writing on tape.

To specify the start position to print to tape, check [Rec In] and enter the timecode. If you click [Cue Up], the tape will cueup to the position of the entered timecode.

6) Click [Next].

7) Confirm the details, and click [Export].

Click [Cancel] to abort the export.
If In and Out points have been set on the timeline, that range will be exported.

INDEX