To export projects created in the stereoscopic edit mode to tape, you must first register the corresponding device preset. Set the export method in the [Output H/W, Format Settings] screen for device presets.
Registration of Device Presets
Combine and export the video of the L and R sides of the project to tape.
Select the following items in the [Settings - Stereoscopic Setting] dialog box for device preset.
[L Only]
[R Only]
[Side by Side]
[Top and Bottom]
[Line Interleave]
[Blend]
[Anaglyph]
[Difference]
[Split Grid]
The operation procedure is the same as regular export to tape.
Exporting to a DV Device (Generic OHCI)
Export the video of the L and R sides of the project to separate tape.
Select [Yes] in [Stereoscopic Separate L/R Clips] for device presets.
1) Perform steps 1) to 7) in Exporting to a DV Device (Generic OHCI) .
The message [Insert L tape] is displayed after step 7) .
2) Insert the tape for the L side into the camera, and click [OK].
Export of L side data is started.
When export ends, the message [Insert R tape] is displayed.
3) Insert the tape for the R side into the camera, and click [OK].
Export of R side data is started.
The [Print To Tape] dialog box disappears when the export finishes.
Click [Cancel] to abort the export.
If In and Out points have been set on the timeline, that range will be exported.
