Partially restoring an asset
You
can partially restore an asset to get a specific part of the high resolution material
from the archive system and restore it into the K2 Summit/SAN system.
Refer to this Topic Library for information on supported formats.
- Load the asset you are partially restoring into the Inspector.
- Set Mark In and Mark Out points on the asset.
-
Click
Actions on the Inspector panel and select
Restore Media.
The Restore Media dialog opens.
-
Select
Partial Asset to partially restore the asset.
Verify that the mark in and mark out points specified on the Restore Media dialog are correct.
-
Enter a new name in the
Asset Name box if desired.
If not, _PR is appended to the name of the asset by default to indicate partial restore.
- Select the desired destination to restore the asset.
-
Click
OK.
Note: Restore operations are not always immediate.
- Verify the status of your restore operation and the names of the assets that are restored by launching Monitors | Jobs from the Navigator.