Startup Mode |
Re-enable rules after
restart and apply only to assets changed after the activation of the
rule: When the GV STRATUS system starts up, rules are enabled but the
Rules Engine does not take action on existing assets. Rather, it waits until an
asset changes and then evaluates the asset to take action.Re-enable
rules after restart and apply to all applicable assets: When the GV
STRATUS system starts up, rules are enabled and the Rules Engine immediately
evaluates existing assets and takes action accordingly. Note: Take care when using
this setting. Assets for which the rule action successfully completed before the
restart can have the rule action applied again after the restart, resulting in a
large amount of unnecessary rule activity.
Do not
re-enable rules after restart: When the GV STRATUS system starts up,
rules are disabled. You must manually re-enable rules.
|
Import Rule File Handling |
Rename imported files: Assets are renamed if imported
via rules conditions by the Rules Engine. Create side-car
files: Assets are not renamed during import, but side-car files
are created for each imported asset. The side-car file is in XML format with
information such as the import start time, end time, import status, and import
destination.
|
Accelerate Metadata Triggered Rules |
Setting to define the percentage of metadata triggers out of all enabled
cyclic trigger rules in the Rules Condition Checker so that metadata triggered
rules can be executed earlier. The default is set to 0%.
Note: Do not change this setting except under advice of Grass Valley Support
personnel.
|
Metadata Trigger Retrieve Cycle |
Setting of the cycle of time to read metadata change notices from the GV STRATUS core services. The default value is set to 3 seconds, but you
can change the duration of time if desired.
Note: Do not change this setting except under advice of Grass Valley Support
personnel.
|
Content Modify Metadata Trigger Filter |
Setting to filter change notices of modified contents in metadata triggered
rules. The default value is currently set to 5, so only every 5th polling cycle
will pass these notices, while all other notices will be skipped.
Note: Do not change this setting except under advice of Grass Valley Support
personnel.
|
Save |
Restarts the Rules engine and applies
changes. |
Cancel |
Reverts to previously saved
setting. |